Use this information to install the hard disk drive cage.
Before you begin
Note: This procedure should be performed only by trained service
technicians.
Before you install the hard disk drive cage, complete
the following steps:- Read Safety and Installation guidelines.
- If the compute node is installed in an Flex System chassis, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
Procedure
To install the hard disk drive cage, complete the following steps.
- Remove the cover (see Removing the compute node cover).
- Position the cage in the bezel at an angle and rotate the cage into position on the system board.
- Align the cage with the screw holes on the system board.
- Using a T8 Torx screwdriver, install the four screws and secure the cage in the compute node.
- Install the hard disk drive backplane (see Installing the hard disk drive backplane).
- Insert the hot-swap hard disk drives and hard disk drive bay fillers (see Installing a hot-swap hard disk drive).
What to do next
- Install the cover onto the compute node (see Installing the compute node cover for instructions).
- Install the compute node into the chassis (see Installing a compute node in a chassis for instructions).