Use this information to remove the chassis bulkhead.
Note: This procedure should be performed only by trained service
technicians.
Before you remove the chassis bulkhead, complete
the following steps:- Read Safety and Installation guidelines.
- If the compute node is installed in a Lenovo Flex System chassis, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
To remove the chassis bulkhead, complete the following steps.
- Remove the cover (see Removing the compute node cover).
- Remove the air baffles.
- Remove the center partition (see Removing the center partition).
- Remove the fabric connectors (see Removing a fabric connector).
- Carefully place the chassis on the side with the front handle side up.
- Using a T8 Torx screwdriver, remove the screws that secure the bulkhead from the bottom of the chassis.
- Carefully return the chassis to the bottom-side-down orientation.
- Using a T8 Torx screwdriver, remove the screws that secure the bulkhead from the sides of the chassis.
- Lift the chassis bulkhead from the chassis.
If you are instructed to return the chassis bulkhead, follow
all packaging instructions, and use any packaging materials for shipping
that are supplied to you.