Use this information to remove the USB enablement
kit.
Before you begin
Before you remove the USB enablement kit, complete the following
steps:
- Read Safety and Installation guidelines.
- If the compute
node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface,
orienting the compute node with the bezel pointing toward you.
Procedure
To remove the USB enablement kit, complete the following
steps.
-
Remove the cover (see Removing the compute node cover).
-
Remove any USB flash drives that are installed in the USB
connectors (see Removing the USB flash drive).
-
Disconnect the USB cable from the system board.
-
Release the retention tab from the side of the chassis
and remove the USB enablement kit from the compute node.
-
Install an air baffle over the DIMM connectors.
Attention: To maintain proper system cooling, do not operate
the compute node without air baffles installed over the DIMM connectors.
What to do next
If you are instructed to
return the USB enablement kit, follow
all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
