Removing a compute node from a chassis

Use this information to remove a compute node from a IBM® Flex System chassis.

Before you begin

Before you remove a compute node, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is operating, shut down the operating system.
  3. Press the power button to turn off the compute node (see Turning off the compute node for more information).

Procedure

To remove the compute node from a chassis, complete the following steps:

  1. Open the front handle as shown in the illustration. The compute node moves out of the node bay approximately 0.6 cm (0.25 inch).
    Graphic illustrating the removal of a IBM Flex System x240 Compute Node Types 7863, 8737, 8738, and 8956 blade server from a chassis
    Attention:
    • To maintain proper system cooling, do not operate the IBM Flex System chassis without a compute node or node bay filler installed in each node bay.
    • When you remove the compute node, note the node bay number. Reinstalling a compute node into a different node bay from the one it was removed from can have unintended consequences. Some configuration information and update options are established according to node bay number. If you reinstall the compute node into a different node bay, you might have to reconfigure the compute node.
  2. Pull the compute node out of the node bay.
  3. Install either a node bay filler or another compute node in the node bay.

What to do next

If you are instructed to return the compute node, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.