Lenovo Flex SystemChassis Management Module 2 command-line interface: service command errors

This topic lists errors for the service command.

See Common errors for a list of error messages that apply to all commands. See service command for information about command syntax and examples of command use.

Table 1. service command errors.
The error table is a multi-row, two-column table where each row describes a CMM CLI command error: column one lists the error reported by the command-line interface and column two describes what the error means.
Error message	Definition
Firmware update is in progress. Try again later, or use the -o flag to override this warning.	A user tries to run a command while the CMM is busy. Run the command using the -o command option to override this warning.
Getting status of debug with USB key failed.	An error occurs while the CMM is reading the status of debug with a USB key.
Invalid option for this blade: -hard".	The user tries to perform a hard restart on a compute node that does not support the hard restart option.
Invalid option for this target: - option where option identifies the illegal command option that was entered.	The user tries to enter a command option for a target that does not support it.
Invalid syntax for this target	A user tries to enter a command that is not correct for the specified command target.
This command cannot be issued right now. The primary CMM is verifying the code level on the standby CMM. Please try again later.	A user tries to perform a virtual reseat (service-level reset) of the primary CMM while it is busy.
This command cannot be issued right now. The primary CMM is verifying the code level on the standby CMM. Please try again later, or use the -o flag to override this warning.	A user tries to perform a virtual reseat (service-level reset) of the primary CMM while it is busy. Run the command using the -o command option to override this warning.
This command cannot be issued right now. The standby CMM is flashing, and a reset might result in a failover. Please try again later.	A user tries to perform a virtual reseat (service-level reset) of the primary CMM while the standby CMM is unable to support failover.
This command cannot be issued right now. The standby CMM is flashing, and a reset might result in a failover. Please try again later, or use the -o flag to override this warning.	A user tries to perform a virtual reseat (service-level reset) of the primary CMM while the standby CMM is unable to support failover. Run the command using the -o command option to override this warning.
This command cannot be issued right now. There is no standby CMM present.	A user tries to perform a virtual reseat (service-level reset) of the primary CMM when no standby CMM is available to support failover.