Lenovo Flex SystemChassis Management Module 2 command-line interface: led command errors

This topic lists errors for the led command.

See Common errors for a list of error messages that apply to all commands. See led command for information about command syntax and examples of command use.

Table 1. led command errors.
The error table is a multi-row, two-column table where each row describes a CMM CLI command error: column one lists the error reported by the command-line interface and column two describes what the error means.
Error message	Definition
'blink' is not supported on blade[node_number] where node_number identifies the compute node.	The targeted compute node does not support the LED blink function.
Error setting system LED.	An error occurs while the CMM is configuring the system LED.
Error setting -loc for blade[node_number] where node_number identifies the compute node.	An error occurs while setting identify LED for the targeted compute node.
Error setting -loc for switch[number] where number identifies the I/O-module bay.	An error occurs while setting identify LED for the targeted I/O module.
Error getting LED information from device	An error occurs while retrieving LED information.
Error turning off information LED	An error occurs while the user is setting the identify LED to off.
The chassis location LED cannot be turned off at this time because one or more blades have their location LED active.	A user issues a command to turn off the chassis identify LED under conditions when this is not allowed.
The location LED cannot be turned off. The module is not in a state which allows this operation	A user issues a command to turn off a module location LED under conditions when this is not allowed.