Use this information to run DSA Preboot.
To run the DSA Preboot diagnostic programs, complete the
following steps:
- If the compute node is turned on, turn off the compute node (see Turning off the compute node).
- If necessary, connect a keyboard, monitor, and mouse to the console breakout cable and
connect the console breakout cable to
the compute node.
- Turn on the compute node (see Turning on the compute node).
- When the prompt
<F2> Diagnostics is displayed,
press F2. - Select Quit from the actions available
on the Memory Test screen.
Note: After you exit the Memory Test screen,
you must restart the compute node to access the stand-alone memory
diagnostic environment again.
- Enter gui to start the DSA graphical user
interface, or select cmd to display the DSA
interactive menu.
- From the diagnostic programs screen, select the test that you
want to run, and follow the instructions on the screen. For additional
information, see Dynamic System Analysis Installation and
User's Guide, which is available at Lenovo Dynamic System Analysis (DSA) website.
Help for DSA is available. For help about the DSA CLI,
enter help in the command line. For help about
the DSA user interface, press F1. Pressing F1 within a help panel
displays additional online documentation.