Lenovo Flex System x240 M5 Compute Node Types 9532 and 2951 - Removing the adapter-retention assembly

Use this information to remove the adapter-retention assembly.

Before you remove the adapter-retention assembly, complete the following steps:

Read Safety and Installation guidelines.
If the compute node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

The adapter-retention assembly consists of five separate parts. You can replace only the parts that you choose and save the unused parts for future use.

To remove the adapter-retention assembly, complete the following steps.

Graphic illustrating removing the adapter-retention assembly

Remove the cover (see Removing the compute node cover).
Remove the air baffles.
If necessary, remove the I/O expansion adapters and Adapter for SD Media (see Removing an I/O expansion adapter and Removing the SD Media Adapter for System x).
Carefully place the chassis on its side with the front handle side up.
Using a T10 Torx screwdriver, remove the screws that secure each part of the adapter-retention assembly that you are removing.

Note: All adapter-attention assembly parts are shown. Replace the parts that are needed and save the unused parts for future use.
Lift each part of the adapter-retention assembly that you are removing from the system board.
Carefully return the chassis to the bottom-side-down orientation.

If you are instructed to return the adapter-retention assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.