The following messages can result when you run the DSA checkpoint panel test.
-
180-000-000
:
Check-point Panel Test Passed
Check-point Panel Test Passed.
- Recoverable
- No
- Severity
- Event
- Serviceable
- No
- Automatically notify support
- No
- Related links
-
180-801-000
:
Check-point Panel Test Aborted
Check-point Panel Test Aborted. BMC is unable to verify that the operator information panel cable is connected.
- Recoverable
- No
- Severity
- Warning
- Serviceable
- Yes
- Automatically notify support
- No
- User Response
- Complete the following steps:
- Inspect and reseat operator information panel cable at both ends.
- Verify that the Baseboard Management Controller (BMC) is working.
- Run the test again.
- If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.
- Related links
-
180-901-000
:
Check-point Panel Test Failed
Check-point Panel Test Failed. Operator reported incorrect display.
- Recoverable
- No
- Severity
- Error
- Serviceable
- Yes
- Automatically notify support
- No
- User Response
- Complete the following steps:
- Check the operator information panel cabling for loose or broken connections at both ends or damage to the cable.
- Replace the information panel cable if damage is present.
- Run the test again.
- Replace the operator information panel assembly.
- Run the test again.
- If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.
- Related links