Remotely over a LAN

If you omit any optional parameter, the default value is used.

To update the UUID, in the ASU command-line interface, enter the following command:

asu set SYSTEM_PROD_DATA.SysInfoUUID uuid --host ipaddress
     [--user userid][--password password]

where:

uuid

is the user-assigned hexadecimal value, up to 16 bytes, that identifies the compute node.

ipaddress

is the external LAN IP address of the IMM2.

userid

is the IMM2 account name (1 of 12 accounts). The default is USERID.

password

is the IMM2 account password (1 of 12 accounts). The default is PASSW0RD (with a zero, not the letter O).

To update the DMI/SMBIOS data, complete the following steps:

1. In the ASU command-line interface, enter the following command:

   asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy --host ipaddress
        [--user userid][--password password]

   Important: The default machine type and model number in the system-board firmware might not be the machine type and model number of the compute node. Make sure that you enter the correct machine type and model number.

   where:

   xxxx

   is the 4-digit machine type of the compute node.

   yyy

   is the 3-digit model number of the compute node.

   ipaddress

   is the external LAN IP address of the IMM2.

   userid

   is the IMM2 account name (1 of 12 accounts). The default is USERID.

   password

   is the IMM2 account password (1 or 12 accounts). The default is PASSW0RD (with a zero, not the letter O).

2. Enter the following command:

   asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz --host ipaddress
        [--user userid][--password password]

   where zzzzzzz is the 7-character serial number of the compute node.

3. Enter the following command:

   asu set SYSTEM_PROD_DATA.SysEncloseAssetTag
        aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa --host ipaddress
        [--user userid][--password password]

   where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number of the compute node.