Use this information to install the chassis bulkhead.
Before you begin
- Read Safety and Installation guidelines.
- If the compute node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
Procedure
To install the chassis bulkhead, complete the following steps.
- Remove the cover (see Removing the compute node cover).
- Remove the fabric connector (see Removing a fabric connector).
- Position the bulkhead in the chassis.
- Using a T8 Torx screwdriver, install the screws that secure the bulkhead to the sides of the chassis.
- Carefully place the chassis on its side with the front handle side up.
- Using a T8 Torx screwdriver, install the screws that secure the bulkhead to the bottom of the chassis.
- Carefully return the chassis to the bottom-side-down orientation.
- Install the fabric connector (see Installing a fabric connector).
- Install the I/O expansion adapters (see Installing an I/O expansion adapter).
- Install the air baffles, if you removed them.
What to do next
- Install the cover onto the compute node (see Installing the compute node cover for instructions).
- Install the compute node into the chassis (see Installing a compute node in a chassis for instructions).