Installing the light path diagnostics panel

Use this information to install the light path diagnostics panel.

Before you begin

Before you install the light path diagnostics panel, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

Procedure

To install a light path diagnostics panel, complete the following steps.

Graphic illustrating the light path diagnostics panel installation

  1. Remove the cover (see Removing the compute node cover).
  2. Connect the cable on the system board.
  3. Align the light path diagnostics panel with the bracket.
  4. Press the light path diagnostics panel securely in the bracket.

What to do next

After you install the light path diagnostics panel, complete the following steps:
  1. Install the cover onto the compute node (see Installing the compute node cover for instructions).
  2. Install the compute node into the chassis (see Installing a compute node in a chassis for instructions).
Parent topic: Removing and replacing Tier 1 customer replaceable units (CRUs)