Explanation
Tape Test Failed. Software error: invalid request.
Severity
Error
Serviceable
Yes
Recoverable
No
Automatically notify Support
No
User response
Complete the following steps:
- If the system has stopped responding, turn off and restart the system.
- Check the system firmware level and upgrade if necessary. The installed firmware level can be found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
- Run the test again.
- If the system has stopped responding, turn off and restart the system.
- Make sure that the drive firmware is at the latest level.
- Run the test again.
- If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.