Explanation
Optical Drive Test Aborted. Could not access the device.
Severity
Warning
Serviceable
Yes
Recoverable
No
Automatically notify Support
No
User response
Complete the following steps:
- Insert a new CD or DVD into the drive and wait for 15 seconds for the media to be recognized. Rerun the test.
- Check the drive cabling for loose or broken connections at both ends or damage to the cable. Replace the cable if damage is present.
- Run the test again.
- Check system firmware level and upgrade if necessary.The installed firmware level can be found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
- Run the test again.
- If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.