Use these instructions to install the front LED card in
the Flex System Enterprise
Chassis.
To install the front LED card, complete the following
steps:
- Connect the cable to the front LED card.
- Align the front LED card with the connector on the chassis
and push it into the connector until it is firmly seated.
- Slide the access cover to the left and then forward to
close it.
- Reinstall the two T-8 Torx screws that you removed earlier.
- Reinstall the chassis shelves (see Replacing a chassis shelf).
- Reinstall the compute nodes (see Replacing a 1-bay compute node or Replacing a 2-bay compute node).
Attention: Be sure to install any compute nodes that
you removed in the same bays from which they were removed. Reinstalling
a compute node into
a different bay from the one from which it was removed can have unintended
consequences.
- Reinstall the management node, if you removed one from
node bays 1 through 8 (see Replacing a Flex System Manager management node for
instructions).
After you install the front LED card, complete the following
steps:
- Reconnect power to the chassis.
- Restart the compute nodes and
the operating systems. See the documentation that comes with your compute nodes for
detail instructions.
- Restart the management node, if one is installed. See the Flex System Manager Installation
and Service Guide for instructions.
