Multiple nodes cannot ping the management node in a different chassis

Use the information in this section to troubleshoot multiple nodes that cannot ping the Flex System Manager management node in a different chassis on the management network.

Action

Complete the following steps until the problem is solved:
  1. Make sure that the management node is powered on and is not hung, by logging in to the management node. If you are unable to log in from the management network, attempt to log in from the data network. If the management node is powered on and hung, perform a virtual reseat of the management node from the CMM.
  2. Make sure that all of the network cables in the communication path are correctly connected.
  3. Make sure that the CMMs (the CMM in the same chassis as the management node and the CMM in the remote chassis) are powered on and are not hung by pinging the CMM from the management node:
    1. If the CMM is powered on and hung, reset the CMM.
    2. Make sure that the IMM, the management node, and the CMM are all on the same subnet.
  4. Make sure that all cables between the CMMs and the top-of-rack switch are correctly connected and secure and that the activity LEDs are lit on the applicable ports
  5. Make sure that the CMMs (the CMM in the same chassis as the management node and the CMM in the remote chassis) have the same subnet address and can ping one another. If they cannot, make sure that the ports on the top-of-rack switch are enabled. Attempt to connect the CMMs directly if possible.
  6. Make sure that the management node has fully discovered the nodes within its chassis by viewing the chassis map. If it has not fully discovered the nodes, follow the steps in Multiple nodes cannot ping the management node in the same chassis.
  7. Make sure that the management processor for each compute node has a valid IP address by checking the chassis map of the remote chassis.
    Note: If the CMM recently lost connection to the DCHP server, you must reset the IMM by using the CMM interface so that a new IP address can be acquired.
    If a system-management processor does not have a valid IP address, complete the following steps:
    1. Restart the CMM in the remote chassis.
    2. Check Lenovo Support for any firmware or software updates that might apply to this issue. You can view the release notes for a firmware update to determine the issues that are addressed by the update.
    3. Remove and reinstall the CMM.
    4. Replace the CMM.
  8. Check Lenovo Support for any service bulletins that are related to network connectivity.
  9. Remove the node and make sure that the connectors on the chassis midplane and the node are not damaged.
  10. (Trained service technician only) Complete the following steps:
    1. Force the link/duplex speed.
    2. Check the connectors on the nodes and the chassis midplane to make sure that no pins are bent.
    3. Replace the I/O expansion card in the management node.
Parent topic: Cannot ping the Flex System Manager management node on the management network