You can configure the Flex System Enterprise
Chassis locally
or remotely by using the Chassis Management Module web
interface. You must use the CMM to
create user accounts and to configure IP addresses for the CMM and
the I/O modules before you power-on the Flex System Manager management
node, if one is installed. Configuring the chassis involves performing
all of the tasks that are necessary to set up a functioning chassis
on which you can begin to install applications.
Note: Before you configure the Flex System Enterprise
Chassis,
make sure that you have completed all installation activities.
To
configure the chassis, complete the following tasks:
- Connect to the CMM web
interface to create user accounts and to configure IP addresses for
the CMM and
the chassis I/O modules (see Configuring the chassis by using the CMM).
Note:
- If the chassis does not have a management node available, use
the Chassis Management Module web
interface to complete the chassis configuration.
- If you have multiple chassis on the management network, you must
establish user accounts and configure the IP addresses using the CMM for
each chassis before you power-on the management node, if one is available.
- If a Lenovo XClarity Administrator is
available, use the Lenovo XClarity Administrator to
discover and configure the Flex System Enterprise
Chassis (see Configuring the chassis by using the Lenovo XClarity Administrator).
- If a Flex System Manager management
node is available, you can connect to the management node and use
the setup wizard to configure the management node (see Configuring the chassis by using the Flex System Manager management node).
After you have completed the initial configuration, you can install
and configure applications.