Use this information to remove the adapter-retention assembly.
Before you begin
Before you remove the adapter-retention assembly, complete
the following steps:
- Read Safety and Installation guidelines.
- If the compute node is installed in an Flex System chassis,
remove it (see Removing a compute node from a chassis for
instructions).
- Carefully lay the compute node on a flat, static-protective surface,
orienting the compute node with the bezel pointing toward you.
About this task
The adapter-retention assembly consists of five separate
parts. You can replace only the parts that you choose and save the
unused parts for future use.
Procedure
To remove the adapter-retention assembly, complete
the following steps.
-
Remove the cover (see Removing the compute node cover).
-
Remove the air baffles.
-
If necessary, remove the I/O expansion adapters (see Removing an I/O expansion adapter).
-
Carefully place the chassis on its side with the front
handle side up.
-
Using a T9 Torx screwdriver, remove the three screws that
secure the adapter-retention assembly.
-
Lift the adapter-retention assembly from the system board.
-
Carefully return the chassis to the bottom-side-down orientation.
What to do next
If you are instructed to return the adapter-retention assembly,
follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
