Installing a bezel - Flex System x222 Compute Node

Use this information to install a bezel. There is a bezel on both the upper and lower compute nodes.

Before you install a bezel, complete the following steps:

Read Safety and Installation guidelines.
If the Flex System x222 Compute Node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward the left.

The upper and lower compute nodes come with separate bezels. Bezels for the upper and lower compute nodes are not interchangeable.

If an upper compute node that you are replacing came with an RFID tag attached to the bezel, you must obtain and install a replacement RFID tag.

To obtain an RFID tag, see Parts listing, Types 7916 and 2589
For installation instructions, see Installing an RFID tag

To install a bezel, complete the following steps.

Position the bezel on the front of the upper or lower compute node. The upper and lower compute node bezels are not interchangeable.
Press the bezel securely against the chassis.
Note: Make sure that the bezel is pressed flat against the chassis around the power button, to maintain access to the power button.

If the upper compute node bezel that you are replacing came with an RFID tag attached to it, install a replacement RFID tag (see Installing an RFID tag).