Installing an RFID tag

Use this information to install an RFID tag from the bezel. The RFID tag for the Flex System x222 Compute Node is installed on the upper compute node.

To install an RFID tag, complete the following steps.

1. Locate the RFID tag location on the upper compute node bezel.
2. Make sure that the surface you are installing the tag on is thoroughly clean and dry.
3. Remove the backing from the base to expose the adhesive.
4. Position the RFID tag over the ID label on the front of the bezel.
5. Press the RFID tag securely against the bezel and hold firmly in place for 30 seconds.
   Note:

   • Allow 30 minutes before pivoting the RFID tag.
   • Allow 24 hours to achieve near maximum adhesion.