4300010E : Complex Descriptor obtained from [arg1] is corrupted. No impact unless all nodes of complex have same error.

Complex Descriptor obtained from [arg1] is corrupted. No impact unless all nodes of complex have same error.

The compute node provided a complex descriptor that is not valid. This will not be an impact unless all compute nodes of the same complex also have this error. If any node does provide a good complex descriptor, that will sufficient for the management module support of partition data.

Severity

Informational

Alert Category

Nodes (Informational)

Log Source

Node_0

Serviceable

No

Recoverable

No

Chassis LED that is Lit

None

CIM Information

Prefix:CMM

and ID:0694

SNMP Trap ID

mmTrapBladeS

Automatically Notify Support

No

User Response

Perform these steps if all the nodes of a complex have this error:
  1. Reset the node system management processor on all compute nodes in the scalable node complex. You can reset the service processor through the chassis management module Web interface from the Node Power/Restart page.
  2. Disconnect the SMP connector and reseat the scalable nodes of the complex.
  3. Update the firmware for the service processor on the specified compute node server. You can find the appropriate firmware on the Flex software and device drivers Web page.