Use these instruction to log in to the IMM2 web interface.
Note:
- If you are logging on to the IMM2 for the first time after installation,
the IMM2 defaults to Dynamic Host Configuration Protocol (DHCP). If
a DHCP host is not available, the IMM2 assigns a static IP address
between 192.168.70.101 and 192.168.70.114, depending on the bay in
which the compute node is installed.
- You can also assign IP addresses through the CMM ifconfig command. For more information about the CMM ifconfig command,
see the "Flex System Chassis Management Module: Command-Line
Interface Reference Guide".
- To assign IP addresses from the CMM web interface, click .
- If the CMM and compute nodes are set to use DHCP, and the CMM
loses connectivity to the network, the CMM attempts to acquire a new
IP address when network connectivity is restored. The compute nodes
will not attempt to acquire an IP address again and the compute node
continues to use their existing IP addresses. Therefore, if you experience
network problems on compute nodes after connectivity between the CMM
and the network has been restored, you might need to reset the system-management
processor on each of the compute nodes in the chassis (including Flex System Manager management
software,
if it is installed).
- The IMM2 user name and password are provisioned through
the CMM. To use tools such as Advanced Settings Utility (ASU) for
out-of-band communications, you must define local user accounts from
the IMM web interface. To define local user accounts from the IMM
web interface, click .
The local user accounts
are valid only for accessing the IMM web interface on this compute
node. However, if you back up the IMM configuration, that backup will
not contain the local user accounts that were created from the IMM
user interface.
- The IMM2 logs you out of the web interface if your browser is
inactive for the number of minutes that you have specified for the
timeout period. To modify the timeout period, from the IMM web interface,
click IMM Management > User > Global Login Settings > General.
- Open a web browser and in the Address or URL field,
type the IP address or host name of the IMM2 to which you want to
connect.
- On the Login page, type the CMM user name and CMM password. You
are then directed to the main page of the IMM2 web interface. If you
are using the IMM2 for the first time, you can obtain the user name
and password from your system administrator. All login attempts are
documented in the IMM event log.