Use the information in this section to troubleshoot a single
compute node that cannot ping the Flex System Manager management
node in a different chassis on the management network.
Complete the following steps until the problem is solved:
- Make sure that the management node is powered on and is not hung,
by logging in to the management node. If you are unable to log in
from the management network, attempt to log in from the data network.
If the management node is powered on and hung, perform a virtual reseat
of the management node from the Chassis Management Module.
- Make sure that the Chassis Management Module is
powered on and is not hung, by pinging the Chassis Management Module from
the management node:
- If the Chassis Management Module is
powered on and hung, reset the Chassis Management Module
- Make sure that the IMM, the management node, and Chassis Management Module are
all on the same subnet.
- Make sure that the compute node is the only one in the chassis
that the management node cannot ping. If it is not, follow the steps
in Multiple nodes cannot ping the management node in the same chassis.
Make sure that the compute node appears on the chassis map (it might
not be fully discovered by the management node software).
- Make sure that the IMM has acquired an IP address from the Chassis Management Module by
using the Setup utility on the compute node.
Note: If the Chassis Management Module recently
lost connection to the DCHP server, you must reset the IMM by using
the Chassis Management Module interface
so that a new IP address can be acquired.
- Make sure that the system-management processor in each compute
node has a valid IP address by checking the chassis map of the remote
chassis.
Note: If the Chassis Management Module recently
lost connection to the DCHP server, you must reset the IMM by using
the Chassis Management Module interface
so that a new IP address can be acquired.
- Check the Lenovo Support Portal for
any firmware updates that might apply to this issue. You can view
the release notes for a firmware update to determine the issues that
are addressed by the update.
- Check the Lenovo Support Portal for
any service bulletins that are related to network connectivity.
- Remove the compute node and make sure that the connectors on the
chassis midplane and the node are not damaged.
- (Trained service technician only) Check the connectors on the
node and the chassis midplane to make sure that no pins are bent.