This access method uses the IPMI/KCS interface. The IPMI
driver must be installed; with some operating systems, the IPMI driver
is installed by default. The ASU provides the corresponding mapping
layer.
To update the UUID, in the ASU command-line interface,
enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoUUID uuid
where uuid is
the user-assigned hexadecimal value, up to 16 bytes, that identifies
the compute node.
To update the DMI/SMBIOS data, complete the
following steps:
- In the ASU command-line interface, enter the following
command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy
Important: The default machine type and model number
in the system-board firmware might not be the machine type and model
number of the compute node. Make sure that you enter the correct machine
type and model number.
where:
- xxxx
- is the 4-digit machine type of the
compute node.
- yyy
- is the 3-digit model number of the
compute node.
- Enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz
where zzzzzzz is
the 7-character serial number of the compute node.
- Enter the following command:
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is
the 33-character asset tag number of the compute node.
- Restart the IMM.
- Restart the server.