Use this information to remove the battery from the CMM.
Note: When a CMM is
no longer needed, remove the battery and recycle or properly dispose
of both the CMM and
battery according to applicable local and national ordinances or regulations.
(See the Environmental Notices and User Guide document on the
Lenovo documentation CD for additional information.)
Before
you remove the battery, complete the following steps:
- Read Safety and Installation guidelines.
- If the CMM is installed in an Flex System Enterprise Chassis, remove it (see Removing a Chassis Management Module for instructions).
To remove the battery, complete the following steps:
- Remove the screws on each side of the CMM cover,
toward the rear of the CMM.
- Open and remove the CMM cover
by lifting the rear edge.
- Locate the battery. The battery is typically toward the
side of the CMM system
board.
- Using your fingernail, press the
battery retaining clip. The battery should pop free.
After removing the battery, dispose of the battery as required
by local ordinances or regulations.