Removing an adapter from the PCIe Expansion Node low-profile PCIe riser

Use these instructions to remove an adapter from the PCIe Expansion Node low-profile PCIe riser.

Before you remove an adapter from the PCIe Expansion Node low-profile PCIe riser, complete the following steps:

Read Safety and Installation guidelines.
If you are not replacing the adapter, you must have a filler to install in the empty slot. Obtain the correct slot filler before continuing.
If the PCIe Expansion Node is installed in a Flex System Enterprise Chassis, remove it (see Removing a PCIe Expansion Node and attached compute node host for instructions).
Carefully lay the PCIe Expansion Node on a flat, static-protective surface with the right side of the unit oriented toward you.
Remove the PCIe Expansion Node cover (see Removing the cover for instructions).

Statement 21

CAUTION:

Hazardous energy is present when the blade is connected to the power source. Always replace the blade cover before installing the blade.

To remove an adapter from the low-profile PCIe riser, complete the following steps.

Grasp the low-profile PCIe riser by the blue touch points and pull the riser straight up to disconnect the riser from the system board connector; then, lift the low-profile PCIe riser out of the PCIe Expansion Node.
Carefully lay the low-profile PCIe riser on it's right side on a flat, static-protective surface with the adapter slots facing up.
Note: The low-profile PCIe riser has two connectors for PCIe adapter cards. The lower connector is for adapter slot 3 and the upper connector is for adapter slot 4.
Pull the adapter out of the slot and remove it from the riser.
Important: Each adapter slot must have either an adapter or a filler installed. If the adapter will not be immediately replaced, install a filler in the adapter slot.

If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Removing a low-profile adapter