Removing a full-height adapter

Use these instructions to remove an adapter from the PCIe Expansion Node full-height PCIe riser.

Before you remove an adapter from the PCIe Expansion Node full-height PCIe riser, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If you are not replacing the adapter, you must have a filler to install in the empty slot. Obtain the correct slot filler before continuing.
  3. If the PCIe Expansion Node is installed in a Flex System Enterprise Chassis chassis, remove it (see Removing a PCIe Expansion Node and attached compute node host for instructions).
  4. Carefully lay the PCIe Expansion Node on a flat, static-protective surface with the right side of the unit oriented toward you.
  5. Remove the PCIe Expansion Node cover (see Removing the cover for instructions).

Statement 21
Graphic illustrating Safety Statement 21

CAUTION:
Hazardous energy is present when the blade is connected to the power source. Always replace the blade cover before installing the blade.

To remove an adapter from the full-height PCIe riser, complete the following steps.

  1. If the installed PCIe adapter is a high-power adapter with an external power cable, disconnect the adapter power cable from the system board (see System board connectors for connector locations).
  2. Grasp the full-height PCIe riser by the blue touch points and pull the riser straight up to disconnect the riser from the system board connector; then, lift the full-height PCIe riser out of the PCIe Expansion Node.

    Graphic illustrating removing a full-height adapter
  3. Carefully lay the full-height PCIe riser on it's left side on a flat, static-protective surface with the adapter slots facing up.
    Note: The full-height PCIe riser has two connectors for PCIe adapters. The lower connector is for adapter slot 1 and the upper connector is for adapter slot 2
  4. Pull the adapter out of the slot and remove it from the PCIe riser.
    Important: Each adapter slot must have either an adapter or a filler installed. If the adapter will not be immediately replaced, install a filler in the adapter slot.

If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.