Using the LSI Logic Configuration Utility

Use these instructions to start the LSI Logic Configuration Utility.

About this task

You can use the LSI Logic Configuration Utility to perform the following tasks:
  • Set the device boot order
  • Add or remove devices from the boot list
  • Manage the RAID configuration
Note: The hard disk drives in the RAID configuration must use the same type of interface and must have identical capacity and speed.

Procedure

To start the LSI Logic Configuration Utility, complete the following steps:

  1. Connect a keyboard, monitor, and mouse to the console breakout cable and connect the console breakout cable to the compute node.
  2. Turn on the compute node (see Turning on the compute node).
  3. When the prompt Press <F1> Setup is displayed, press F1. If you have set an administrator password, you must type the administrator password to access the full Setup utility menu. If you do not type the administrator password, a limited Setup utility menu is available.
  4. From the Setup utility main menu, select System Settings; then select Storage.
  5. Use the arrow keys to select the controller from the list of adapters; then, press Enter.
  6. Follow the instructions on the screen to change the settings of the selected items; then, press Enter. If you select SAS Topology or Advanced Adapter Properties, additional screens are displayed.