Use this information to install the front handle.
Before you begin
Before you install the front handles, complete the following
steps:
- Read Safety and Installation guidelines.
- If the compute node is installed in an Flex System chassis,
remove it (see Removing a compute node from a chassis for
instructions).
- Carefully lay the compute node on a flat, static-protective surface
with the cover side down, orienting the compute node with the bezel
pointing toward you.
Procedure
To install the front handles, complete the following
steps.
-
Orient the front handles so that the blue release latches
are toward the middle of the compute node.
-
Align the hole in the handles with the holes on the compute
node where the handles are installed.
-
Using a T8 Torx screwdriver, install the screw that secures
each handle. Use the screws that you removed when you removed the
handles.
What to do next
After you install the front handles, install the compute
node into the chassis (see
Installing a compute node in a chassis for
instructions).
