Turning on the compute node

After you connect the compute node to power through the Flex System chassis, the compute node can be started in any of the following ways:

• You can press the power button on the front of the compute node (see Compute node controls, connectors, and LEDs) to start the compute node. The power button works only if local power control is enabled for the compute node. Local power control is enabled and disabled through the CMM power command and the CMM web interface.
  • For more information about the CMM power command, see the "Flex System Chassis Management Module: Command-Line Interface Reference Guide".
  • From the CMM web interface, select Compute Nodes from the Chassis Management menu. All fields and options are described in the CMM web interface online help. For more information, see the "Flex System Chassis Management Module: User’s Guide".
  Notes:

  1. Wait until the power LED on the compute node flashes slowly before you press the power button. While the IMM2 in the compute node is initializing and synchronizing with the Chassis Management Module, the power LED flashes rapidly, and the power button on the compute node does not respond. This process can take approximately 90 seconds after the compute node has been installed.
  2. While the compute node is starting, the power LED on the front of the compute node is lit and does not flash. See Compute node controls, connectors, and LEDs for the power LED states.
  3. When you press the power-control button on any compute node in a single partition (controlled by one operating system), all compute nodes in the single partition will be turned on or turned off.
• If a power failure occurs, the Flex System chassis and the compute node can be configured through the CMM power command and the CMM web interface to start automatically when power is restored.
  • For more information about the CMM power command, see the "Flex System Chassis Management Module: Command-Line Interface Reference Guide".
  • From the CMM web interface, select Compute Nodes from the Chassis Management menu. For more information, see the "Flex System Chassis Management Module: User’s Guide". All fields and options are described in the CMM web interface online help.
• You can turn on the compute node through the CMM power command, the CMM web interface, or Flex System Manager management software if installed.
  • For more information about the CMM power command, see the "Flex System Chassis Management Module: Command-Line Interface Reference Guide".
  • From the CMM web interface, select Compute Nodes from the Chassis Management menu. All fields and options are described in the CMM web interface online help. For more information, see the "Flex System Chassis Management Module: User’s Guide".
  • For more information about Flex System Manager management software, see the "Flex System Manager Software: Installation and Service Guide".
• You can turn on the compute node through the Wake on LAN feature. The compute node must be connected to power (the power LED is flashing slowly) and must be communicating with the Chassis Management Module. The operating system must support the Wake on LAN feature, and the Wake on LAN feature must be enabled through the Chassis Management Module interface.