406-903-000
IANet:Interrupts Test Failed

Explanation

A failure was detected during the Interrupt test.

Severity

Error

Serviceable

Yes

Recoverable

No

Automatically notify Support

No

User response

Complete the following steps:
  1. Check component firmware level and upgrade if necessary. The installed firmware level can be found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
  2. Rerun the test.
  3. Check interrupt assignments in the PCI Hardware section of the DSA Diagnostic Log. If the ethernet device is sharing interrupts, if possible modify the interrupt assignments using F1 Setup to assign a unique interrupt to the device.
  4. Rerun the test.
  5. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.

Related Links